Crankshaft Position Sensor
GS8513
Test notes: This type of sensor has three terminals, but only two are connected to an inductor that generates the voltage signals when varying the magnetic field. The third terminal is a shield around the cable to avoid interference and is connected to the vehicle ground. You do not need to connect it to perform this test.To perform the test, follow the procedure:1. In the sensors test module, adjust the LCD display to show the frequency2. Connect the sensors test cables (PU02) to the available “IN” and “GND” inputs below the LCD display and the smaller terminals on the sensor to be tested, as shown in the image3. Connect the Auxiliary Coil (BA01) to the “R/EXT” and “NEG” inputs available on the coils test module. It will generate the magnetic field required for the sensor operation4. Activate the “Modules/Coils” test module and bring the Auxiliary Coil tip closer to the speed sensor tip. The sensor will start generating the signal and the LCD display should show the value of the sensor operating frequency5. The frequency can be changed between 50Hz and 400Hz by pressing the speed button on the “Modules/Coils” test module and, by changing the speed, the frequency shown on the LCD display must also vary
Order: - SIGNAL *
