Ignition Coil
GC4298

Number of outputs: 4

Test notes: "This coil has an integrated ignition module and each pin “IN” of the connector controls two high voltage outputs of the coil, therefore, the outputs must be tested in pairs, according to the numbers indicated in the image. To perform the test, follow the procedure below:• Connect the red cable from the modules testing harness (RM02) to the “B+” pin on the coil, the black cable from the harness to the “B-” pin and the orange cable to the “IN” pin that controls a pair of coil outputs• Connect the high voltage cables from the equipment to the high voltage outputs of the coil, noting that the outputs are related to the connected input pin• Select the Hall type signal (2) in the Modules/Coils test section, activate this section and observe the spark gap. There must be a spark in two electrodes, indicating the correct operation of the two outputs being tested• Disable the Modules/Coils test section and switch the orange cable from one “IN” pin to the other, which controls another pair of outputs. Switch the high voltage cables from the previous outputs to the new ones and repeat the test. Again, there must be a spark in both electrodes"

Product info »
Compare

Compare up to 3 products

Preloader